RAV4 Drivers Club Guideline to Changing Entrance Brake Pads and Discs

During this tutorial we’ll be on the lookout on the approach for changing the entrance pads on the popular 4.3 (Variation 3 from 2006 to 2012).https://4wdlife.com/best-brake-caliper-paints Observe – the procedure is analogous for your RAV4.2 and the exact same with the RAV4.4.

Difficulty – Effortless
Time – About an hour or so both sides.
Tools –
Jack and axle stands.
Wheel brace and locking nut critical.
14mm socket or spanner.
17mm socket.
A range of data files, abrasives and cleaning resources

Always perform in well lit and ventilated situations

Introduction

The brake pads to the front in the RAV4 are concerning the most straightforward to alter that you simply will at any time arrive across. The pads are mounted within a floating caliper which has an individual piston and as well as a bridge which applies the outboard pad with an equivalent and reverse drive. The disc is mounted specifically within the hub without having fixings. Up right until 2009, the pads on the 4.three have been made by a Japanese organization and were being susceptible to transferring some of the content onto the disc. This might result in extreme corrosion and DTV (disc thickness variation) – a wobble or vibration which could be felt as a result of the vehicle when braking. Within this circumstance the sole answer would be to equipment or exchange the discs. Discs ought to only be machined when the bare minimum thickness of 25mm just isn’t exceeded and afterwards consideration to value performance needs to be taken.

Motor vehicles after 2009 had been equipped with a much more abrasive German friction product. In actual fact this has the influence of maintaining the discs clean and correct. Most often the ratio of pad/disc dress in is not really superior than 2:1 and in some circumstances one:one. Good quality discs produced from gray cast iron are readily available. brake pads are offered out of your Toyota Supplier who’ll article them for you in a discounted rate. The initial products brake pads in publish 2009 RAVs is Textar T4146. Keep away from old stock which could possibly be the troublesome early content – marked “Advics”.

Other suitable friction elements are;

Apec
Ferodo Premier
Pagid (Eurocarparts)
Mintex

Be aware. Many of these suppliers market place a funds model that is made to contend with inexpensive imports. Frequently you get that which you buy so always try to supply top quality components. If in doubt – talk to.

The car used in this tutorial incorporates a mileage of approximately forty,000 Miles

Process

Using the street wheel eliminated and the motor vehicle spot safely and securely on stands, clear away the two bolts from the caliper (14mm spanner or socket). Wriggle the caliper and slide it from the disc. It could now be suspended on a bit of wire. Don’t hang it to the pipe. At this stage it is possible to take away the pads through the carrier. Continue to keep them of their respective destinations so as to duplicate the positions in the shims and clips. Be aware. Previously pads had been fitted having an audible have on indicator. This goes into the inside of along with the leading. It is absent from put up 2009 models. Next, undo and take away the two bolts that keep the provider to the hub (17mm socket and prolonged bar – limited!). While using the disc uncovered, you can now have a lump hammer and tap off the disc. When the discs are for being re-used, don’t disturb them. When they need to be eradicated for entry to one more ingredient, you should definitely use a piece of wood for protection